Tier 5 Standard

JIM BARNA LOG SYSTEMS

📍 22459 NORTH ALBERTA STREET, ONEIDA, TN 37841🏭 Veneer, Plywood, and Engineered Wood Product Manufacturing (NAICS 321213)📅 2004-09-14
$3,200.00
Total Penalties
7
Citations
3/100
Risk Score
390
Analysis Words
Enforcement Analysis

According to U.S. Department of Labor enforcement records, JIM BARNA LOG SYSTEMS — a veneer, plywood, and engineered wood product manufacturing facility located at 22459 NORTH ALBERTA STREET, ONEIDA, TN 37841 — was the subject of a formal OSHA inspection that resulted in 7 citation(s) and cumulative proposed penalties of $3,200.00. The inspection case was opened on 2004-09-14.

DOL records document workplace safety violations warranting formal citation under the OSH Act. While classified at the standard enforcement level, all OSHA citations require corrective action and may indicate areas where workplace safety programs should be strengthened.

BLS Injury Data: According to the Bureau of Labor Statistics (2022), this industry sector has an occupational injury rate of 3.3 per 100 full-time workers — 22% above the national average of 2.7. The sector fatality rate is 2.3 per 100,000 workers.

Industry Benchmark: The total penalty of $3,200.00 is 62% below the national average of $8,414.32 for facilities in the Manufacturing sector (NAICS 321213). This sector encompasses 52,095 inspected facilities nationwide with aggregate penalties totaling $438.3M.

State Context: Within TN, this facility's penalty places it at the 87th percentile among 40,481 inspected facilities. The statewide average penalty is $1,620.08.

Citation Analysis: The inspection produced 7 citations spanning 5 distinct OSHA regulatory standards. The citation breakdown includes: 3 serious — A workplace hazard that could cause death or serious physical harm exists, and the employer knew or should have known about the condition. 4 other-than-serious — The violation has a direct relationship to job safety and health but is unlikely to cause death or serious physical harm.

Enforcement Timeline: Citations were issued beginning July 5, 2000 with the latest abatement deadline set for October 31, 2004. Of the 7 total citations, 7 (100%) have been marked as abated in DOL records, indicating substantial compliance with corrective action requirements.

Penalty Assessment: The total proposed penalty of $3,200.00 falls within OSHA's standard enforcement range and may have been adjusted through informal settlement conference procedures, penalty reduction factors, or good faith credit for demonstrated safety and health management systems.

Citation Matrix — 7 Citations
29 CFR 1910.219(e)(03)
Mechanical Power Transmission
Serious
Penalty: $1,600.00Gravity: nanIssued: July 5, 2000Abated: ✓ Yes
29 CFR 1910.22(d)(01)
Walking-Working Surfaces — General
Other-than-Serious
Penalty: $100.00Gravity: nanIssued: July 5, 2000Abated: ✓ Yes
29 CFR 1910.253(b)(04)
Other-than-Serious
Penalty: $100.00Gravity: nanIssued: July 5, 2000Abated: ✓ Yes
29 CFR 1910.305(g)(01)
Electrical — Wiring Methods & Components
Other-than-Serious
Penalty: $100.00Gravity: nanIssued: July 5, 2000Abated: ✓ Yes
OSHA Std. 90007
Serious
Penalty: $100.00Gravity: nanIssued: July 5, 2000Abated: ✓ Yes
29 CFR 1910.22(c)
Walking-Working Surfaces — General
Serious
Penalty: $1,200.00Gravity: nanIssued: October 14, 2004Abated: ✓ Yes
29 CFR 1910.304(e)(01)
Electrical — Wiring Design & Protection
Other-than-Serious
Penalty: $0.00Gravity: nanIssued: October 14, 2004Abated: ✓ Yes
This report is compiled from publicly available U.S. Department of Labor enforcement data under the Freedom of Information Act. SVEP Navigator is an independent research and analysis platform and is not affiliated with, endorsed by, or connected to OSHA, the Department of Labor, or any federal agency. Information is provided for research, educational, and compliance planning purposes only and does not constitute legal advice. Penalty amounts shown are proposed penalties and may have been modified through contest proceedings or settlement.
Local Competitor Benchmark

Comparing penalized facilities in ONEIDA, TN (Broader Sector)

JIM BARNA LOG SYSTEMS (This Facility)
$3.2K
7 cit.
JAMES NATHAN MARCUM
$7.5K
27 cit.
BARNA LOG HOMES LLC
$2.5K
8 cit.
HBD THERMOID INC
$1.8K
3 cit.
More TN Enforcement Records
KILGORE FLARES COMPANY LLC
TOONE, TN
$541.9K
70 cit.
HANKOOK TIRE MANUFACTURING TENNESSEE LP
CLARKSVILLE, TN
$282.5K
40 cit.
YAMAKAWA MANUFACTURING CORPORATION OF AMERICA
PORTLAND, TN
$217.6K
50 cit.
HANKOOK & COMPANY ES AMERICA CORP.
CLARKSVILLE, TN
$189.2K
45 cit.
VALERO REFINING COMPANY-TENNESSEE LLC
MEMPHIS, TN
$172.9K
58 cit.
Other Inspected Facilities in ONEIDA, TN
IRON CORE CONSTRUCTION
$111.9K
5 cit.
CHITWOOD CONSTRUCTION WINFIELD, TN, USA
$13.1K
4 cit.
ONEIDA NURSING/REHAB CENTER
$8.0K
18 cit.
JAMES NATHAN MARCUM
$7.5K
27 cit.
HBD INDUSTRIES INCORPORATED
$5.7K
30 cit.
Related Guides & Tools
OSHA Fines & Penalties Guide →
How OSHA calculates penalties and maximum fine amounts.
Top 10 OSHA Violations →
The most frequently cited standards nationwide.
Manufacturing Safety Data →
Industry-wide violation stats and rankings.
Penalty Calculator →
Estimate fines by violation type, industry, and size.

Explore more: OSHA enforcement in ONEIDA · Tennessee data · Search the database · Incident Rate Calculator

Frequently Asked Questions
What OSHA violations was JIM BARNA LOG SYSTEMS cited for?

JIM BARNA LOG SYSTEMS received 7 citation(s) covering 5 distinct OSHA standards. Total proposed penalties were $3,200.00. The inspection opened on 2004-09-14.

How much was JIM BARNA LOG SYSTEMS fined by OSHA?

OSHA proposed penalties of $3,200.00 against JIM BARNA LOG SYSTEMS in ONEIDA, TN. Average per citation: $457.14.

Is JIM BARNA LOG SYSTEMS a safe workplace?

Based on enforcement records, JIM BARNA LOG SYSTEMS has a risk score of 3 out of 100. DOL records document workplace safety violations warranting formal citation under the OSH Act. While classified at the standard enforcement level, all OSHA citations require corrective action and may indicate areas where workplace safety programs should be strengthened.

How does this penalty compare to the industry average?

The average penalty for Veneer, Plywood, and Engineered Wood Product Manufacturing facilities is $8,414.32. This facility penalty of $3,200.00 is below the industry average.