CONTROL POINT MACHINING & FABRICATION
According to U.S. Department of Labor enforcement records, CONTROL POINT MACHINING & FABRICATION — a machine shops facility located at 3416 CHESTERFIELD AVENUE, CHARLESTON, WV 25304 — was the subject of a formal OSHA inspection that resulted in 2 citation(s) and cumulative proposed penalties of $2,040.00. The inspection case was opened on 2012-11-16.
DOL records document workplace safety violations warranting formal citation under the OSH Act. While classified at the standard enforcement level, all OSHA citations require corrective action and may indicate areas where workplace safety programs should be strengthened.
BLS Injury Data: According to the Bureau of Labor Statistics (2022), this industry sector has an occupational injury rate of 3.3 per 100 full-time workers — 22% above the national average of 2.7. The sector fatality rate is 2.3 per 100,000 workers.
EPA Environmental Record: The EPA shows no current violations for this facility. regulated under: RCRA Hazardous Waste. Source: EPA ECHO database.
Industry Benchmark: The total penalty of $2,040.00 is 68% below the national average of $6,436.62 for facilities in the Manufacturing sector (NAICS 332710). This sector encompasses 82,943 inspected facilities nationwide with aggregate penalties totaling $533.9M.
State Context: Within WV, this facility's penalty places it at the 71th percentile among 14,536 inspected facilities. The statewide average penalty is $3,060.20.
Citation Analysis: The inspection produced 2 citations spanning 2 distinct OSHA regulatory standards. The citation breakdown includes: 2 serious — A workplace hazard that could cause death or serious physical harm exists, and the employer knew or should have known about the condition.
Enforcement Timeline: Citations were issued beginning January 31, 2013 with the latest abatement deadline set for February 12, 2013. Of the 2 total citations, 0 (0%) have been marked as abated in DOL records, which may indicate ongoing compliance gaps requiring further regulatory attention.
Penalty Assessment: The total proposed penalty of $2,040.00 falls within OSHA's standard enforcement range and may have been adjusted through informal settlement conference procedures, penalty reduction factors, or good faith credit for demonstrated safety and health management systems.
This facility's $2,040 penalty is higher than 20% of all penalized companies in the NAICS 332710 industry in WV. The state average penalty for this industry is $6,228.
Comparing penalized facilities in CHARLESTON, WV (Broader Sector)
Explore more: OSHA enforcement in CHARLESTON · West Virginia data · Search the database · Incident Rate Calculator
What OSHA violations was CONTROL POINT MACHINING & FABRICATION cited for?
CONTROL POINT MACHINING & FABRICATION received 2 citation(s) covering 2 distinct OSHA standards. Total proposed penalties were $2,040.00. The inspection opened on 2012-11-16.
How much was CONTROL POINT MACHINING & FABRICATION fined by OSHA?
OSHA proposed penalties of $2,040.00 against CONTROL POINT MACHINING & FABRICATION in CHARLESTON, WV. Average per citation: $1,020.00.
Is CONTROL POINT MACHINING & FABRICATION a safe workplace?
Based on enforcement records, CONTROL POINT MACHINING & FABRICATION has a risk score of 1 out of 100. DOL records document workplace safety violations warranting formal citation under the OSH Act. While classified at the standard enforcement level, all OSHA citations require corrective action and may indicate areas where workplace safety programs should be strengthened.
How does this penalty compare to the industry average?
The average penalty for Machine Shops facilities is $6,436.62. This facility penalty of $2,040.00 is below the industry average.