SWANSON SHEETMETAL, INC.
According to U.S. Department of Labor enforcement records, SWANSON SHEETMETAL, INC. — a all other miscellaneous fabricated metal product manufacturing facility located at 320 BROOME ST., MONROE, NC 28110 — was the subject of a formal OSHA inspection that resulted in 5 citation(s) and cumulative proposed penalties of $1,550.00. The inspection case was opened on 2009-01-15.
DOL records document workplace safety violations warranting formal citation under the OSH Act. While classified at the standard enforcement level, all OSHA citations require corrective action and may indicate areas where workplace safety programs should be strengthened.
BLS Injury Data: According to the Bureau of Labor Statistics (2022), this industry sector has an occupational injury rate of 3.3 per 100 full-time workers — 22% above the national average of 2.7. The sector fatality rate is 2.3 per 100,000 workers.
EPA Environmental Record: The EPA shows no current violations for this facility. regulated under: RCRA Hazardous Waste. Source: EPA ECHO database.
Industry Benchmark: The total penalty of $1,550.00 is 76% below the national average of $6,436.62 for facilities in the Manufacturing sector (NAICS 332999). This sector encompasses 82,943 inspected facilities nationwide with aggregate penalties totaling $533.9M.
State Context: Within NC, this facility's penalty places it at the 75th percentile among 88,256 inspected facilities. The statewide average penalty is $1,699.39.
Citation Analysis: The inspection produced 5 citations spanning 4 distinct OSHA regulatory standards. The citation breakdown includes: 5 serious — A workplace hazard that could cause death or serious physical harm exists, and the employer knew or should have known about the condition.
Enforcement Timeline: Citations were issued beginning May 12, 2009 with the latest abatement deadline set for May 3, 2013. Of the 5 total citations, 5 (100%) have been marked as abated in DOL records, indicating substantial compliance with corrective action requirements.
Penalty Assessment: The total proposed penalty of $1,550.00 falls within OSHA's standard enforcement range and may have been adjusted through informal settlement conference procedures, penalty reduction factors, or good faith credit for demonstrated safety and health management systems.
This facility's $1,550 penalty is higher than 46% of all penalized companies in the NAICS 332999 industry in NC. The state average penalty for this industry is $3,718.
Comparing penalized facilities in MONROE, NC (Exact Industry)
Explore more: OSHA enforcement in MONROE · North Carolina data · Search the database · Incident Rate Calculator
What OSHA violations was SWANSON SHEETMETAL, INC. cited for?
SWANSON SHEETMETAL, INC. received 5 citation(s) covering 4 distinct OSHA standards. Total proposed penalties were $1,550.00. The inspection opened on 2009-01-15.
How much was SWANSON SHEETMETAL, INC. fined by OSHA?
OSHA proposed penalties of $1,550.00 against SWANSON SHEETMETAL, INC. in MONROE, NC. Average per citation: $310.00.
Is SWANSON SHEETMETAL, INC. a safe workplace?
Based on enforcement records, SWANSON SHEETMETAL, INC. has a risk score of 2 out of 100. DOL records document workplace safety violations warranting formal citation under the OSH Act. While classified at the standard enforcement level, all OSHA citations require corrective action and may indicate areas where workplace safety programs should be strengthened.
How does this penalty compare to the industry average?
The average penalty for All Other Miscellaneous Fabricated Metal Product Manufacturing facilities is $6,436.62. This facility penalty of $1,550.00 is below the industry average.