Tier 5 Standard

PORTERS FABRICATIONS

📍 1485 DIEBOLD DRIVE, SUMTER, SC 29153🏭 Fabricated Structural Metal Manufacturing (NAICS 332312)📅 2011-06-01
$1,875.00
Total Penalties
6
Citations
3/100
Risk Score
384
Analysis Words
Enforcement Analysis

According to U.S. Department of Labor enforcement records, PORTERS FABRICATIONS — a fabricated structural metal manufacturing facility located at 1485 DIEBOLD DRIVE, SUMTER, SC 29153 — was the subject of a formal OSHA inspection that resulted in 6 citation(s) and cumulative proposed penalties of $1,875.00. The inspection case was opened on 2011-06-01.

DOL records document workplace safety violations warranting formal citation under the OSH Act. While classified at the standard enforcement level, all OSHA citations require corrective action and may indicate areas where workplace safety programs should be strengthened.

BLS Injury Data: According to the Bureau of Labor Statistics (2022), this industry sector has an occupational injury rate of 3.3 per 100 full-time workers — 22% above the national average of 2.7. The sector fatality rate is 2.3 per 100,000 workers.

Industry Benchmark: The total penalty of $1,875.00 is 71% below the national average of $6,436.62 for facilities in the Manufacturing sector (NAICS 332312). This sector encompasses 82,943 inspected facilities nationwide with aggregate penalties totaling $533.9M.

State Context: Within SC, this facility's penalty places it at the 89th percentile among 39,390 inspected facilities. The statewide average penalty is $977.57.

Citation Analysis: The inspection produced 6 citations spanning 2 distinct OSHA regulatory standards. The citation breakdown includes: 5 serious — A workplace hazard that could cause death or serious physical harm exists, and the employer knew or should have known about the condition. 1 other-than-serious — The violation has a direct relationship to job safety and health but is unlikely to cause death or serious physical harm.

Enforcement Timeline: Citations were issued beginning August 16, 2011 with the latest abatement deadline set for September 30, 2011. Of the 6 total citations, 6 (100%) have been marked as abated in DOL records, indicating substantial compliance with corrective action requirements.

Penalty Assessment: The total proposed penalty of $1,875.00 falls within OSHA's standard enforcement range and may have been adjusted through informal settlement conference procedures, penalty reduction factors, or good faith credit for demonstrated safety and health management systems.

Industry Benchmark (SC)

This facility's $1,875 penalty is higher than 54% of all penalized companies in the NAICS 332312 industry in SC. The state average penalty for this industry is $3,258.

$3,258
State Avg
$1,875
This Facility
Citation Matrix — 6 Citations
29 CFR 1910.1000(a)(01)
Serious
Penalty: $1,875.00Gravity: 03Issued: August 16, 2011Abated: ✓ Yes
29 CFR 1910.1000(e)
Serious
Penalty: $0.00Gravity: 01Issued: August 16, 2011Abated: ✓ Yes
29 CFR 1910.134(f)(02)
Fall Protection — General Requirements
Serious
Penalty: $0.00Gravity: 01Issued: August 16, 2011Abated: ✓ Yes
29 CFR 1910.134(h)(02)
Fall Protection — General Requirements
Serious
Penalty: $0.00Gravity: 01Issued: August 16, 2011Abated: ✓ Yes
29 CFR 1910.134(k)(05)
Fall Protection — General Requirements
Serious
Penalty: $0.00Gravity: 01Issued: August 16, 2011Abated: ✓ Yes
29 CFR 1910.134(c)(02)
Fall Protection — General Requirements
Other-than-Serious
Penalty: $0.00Gravity: 01Issued: August 16, 2011Abated: ✓ Yes
This report is compiled from publicly available U.S. Department of Labor enforcement data under the Freedom of Information Act. SVEP Navigator is an independent research and analysis platform and is not affiliated with, endorsed by, or connected to OSHA, the Department of Labor, or any federal agency. Information is provided for research, educational, and compliance planning purposes only and does not constitute legal advice. Penalty amounts shown are proposed penalties and may have been modified through contest proceedings or settlement.
Local Competitor Benchmark

Comparing penalized facilities in SUMTER, SC (Exact Industry)

PORTERS FABRICATIONS (This Facility)
$1.9K
6 cit.
74236 - MERCHANT IRON WORKS INC
$7.5K
8 cit.
73672 - PORTERS FABRICATIONS SUMTER LLC
$2.3K
1 cit.
More SC Enforcement Records
ALBRIGHT & WILSON AMERICAS, INC.
CHARLESTON, SC
$900.3K
43 cit.
FRIGIDAIRE HOME PRODUCTS
ORANGEBURG, SC
$447.1K
129 cit.
PHILIP SERVICES CORPORATION
CHARLESTON, SC
$270.6K
46 cit.
BEACH BUNGEE, INC.
NORTH MYRTLE BEACH, SC
$244.0K
6 cit.
CHARLESTON SHIPBUILDERS, INC.
CHARLESTON, SC
$200.9K
48 cit.
Other Inspected Facilities in SUMTER, SC
GOLD KIST INC. SC POULTRY DIV.
$175.5K
90 cit.
CAROLINA GOLDEN PRODUCTS
$110.9K
91 cit.
MIDWEST STAMPING, INC.
$42.5K
72 cit.
MADISON INDUSTRIES, INC.
$40.7K
79 cit.
MIDWEST STAMPING, INC. - SUMTER PLANT
$38.0K
25 cit.
Related Guides & Tools
OSHA Fines & Penalties Guide →
How OSHA calculates penalties and maximum fine amounts.
Top 10 OSHA Violations →
The most frequently cited standards nationwide.
Manufacturing Safety Data →
Industry-wide violation stats and rankings.
Penalty Calculator →
Estimate fines by violation type, industry, and size.

Explore more: OSHA enforcement in SUMTER · South Carolina data · Search the database · Incident Rate Calculator

Frequently Asked Questions
What OSHA violations was PORTERS FABRICATIONS cited for?

PORTERS FABRICATIONS received 6 citation(s) covering 2 distinct OSHA standards. Total proposed penalties were $1,875.00. The inspection opened on 2011-06-01.

How much was PORTERS FABRICATIONS fined by OSHA?

OSHA proposed penalties of $1,875.00 against PORTERS FABRICATIONS in SUMTER, SC. Average per citation: $312.50.

Is PORTERS FABRICATIONS a safe workplace?

Based on enforcement records, PORTERS FABRICATIONS has a risk score of 3 out of 100. DOL records document workplace safety violations warranting formal citation under the OSH Act. While classified at the standard enforcement level, all OSHA citations require corrective action and may indicate areas where workplace safety programs should be strengthened.

How does this penalty compare to the industry average?

The average penalty for Fabricated Structural Metal Manufacturing facilities is $6,436.62. This facility penalty of $1,875.00 is below the industry average.