Tier 4 Systematic

BID-WELL DIVISION OF CMI CORPORATION

📍 329 SOUTH MAIN, CANTON, SD 57013🏭 Construction Machinery Manufacturing (NAICS 333120)📅 2003-02-04
$568.75
Total Penalties
21
Citations
20/100
Risk Score
382
Analysis Words
Enforcement Analysis

According to U.S. Department of Labor enforcement records, BID-WELL DIVISION OF CMI CORPORATION — a construction machinery manufacturing facility located at 329 SOUTH MAIN, CANTON, SD 57013 — was the subject of a formal OSHA inspection that resulted in 21 citation(s) and cumulative proposed penalties of $568.75. The inspection case was opened on 2003-02-04.

The volume of citations issued during this inspection suggests systematic compliance deficiencies rather than isolated incidents. Facilities with 10 or more citations typically face comprehensive abatement requirements and may be subject to follow-up inspections.

BLS Injury Data: According to the Bureau of Labor Statistics (2022), this industry sector has an occupational injury rate of 3.3 per 100 full-time workers — 22% above the national average of 2.7. The sector fatality rate is 2.3 per 100,000 workers.

Industry Benchmark: The total penalty of $568.75 is 91% below the national average of $6,436.62 for facilities in the Manufacturing sector (NAICS 333120). This sector encompasses 82,943 inspected facilities nationwide with aggregate penalties totaling $533.9M.

State Context: Within SD, this facility's penalty places it at the 65th percentile among 6,675 inspected facilities. The statewide average penalty is $2,764.62.

Citation Analysis: The inspection produced 21 citations spanning 10 distinct OSHA regulatory standards. The citation breakdown includes: 4 serious — A workplace hazard that could cause death or serious physical harm exists, and the employer knew or should have known about the condition. 11 other-than-serious — The violation has a direct relationship to job safety and health but is unlikely to cause death or serious physical harm.

Enforcement Timeline: Citations were issued beginning August 4, 1988 with the latest abatement deadline set for March 21, 2003. Of the 21 total citations, 14 (67%) have been marked as abated in DOL records, suggesting partial progress toward required corrective actions.

Penalty Assessment: The total proposed penalty of $568.75 falls within OSHA's standard enforcement range and may have been adjusted through informal settlement conference procedures, penalty reduction factors, or good faith credit for demonstrated safety and health management systems.

Industry Benchmark (SD)

This facility's $569 penalty is higher than 10% of all penalized companies in the NAICS 333120 industry in SD. The state average penalty for this industry is $4,407.

$4,407
State Avg
$569
This Facility
Citation Matrix — 21 Citations
29 CFR 1910.212(a)(01)
Machine Guarding — General Requirements
Serious
Penalty: $218.75Gravity: 04Issued: May 14, 1992Abated: ✓ Yes
29 CFR 1910.212(a)(03)
Machine Guarding — General Requirements
Serious
Penalty: $0.00Gravity: 04Issued: May 14, 1992Abated: ✓ Yes
29 CFR 1910.217(c)(01)
Mechanical Power Presses
Serious
Penalty: $0.00Gravity: 04Issued: May 14, 1992Abated: ✓ Yes
29 CFR 1910.254(d)(09)
Other-than-Serious
Penalty: $0.00Gravity: 01Issued: May 14, 1992Abated: ✓ Yes
29 CFR 1910.212(a)(05)
Machine Guarding — General Requirements
Other-than-Serious
Penalty: $0.00Gravity: 01Issued: May 14, 1992Abated: ✓ Yes
29 CFR 1910.303(b)(01)
Electrical — General Requirements
Other-than-Serious
Penalty: $0.00Gravity: 01Issued: May 14, 1992Abated: ✓ Yes
29 CFR 1910.1200(e)(01)
Hazard Communication Standard (Chemical Safety)
Other-than-Serious
Penalty: $0.00Gravity: 01Issued: May 14, 1992Abated: ✓ Yes
29 CFR 1910.106(d)(04)
Serious
Penalty: $350.00Gravity: 02Issued: May 11, 2000Abated: ✓ Yes
29 CFR 1910.107(b)(10)
Other-than-Serious
Penalty: $0.00Gravity: 01Issued: May 11, 2000Abated: ✓ Yes
29 CFR 1910.95(g)(01)
Other-than-Serious
Penalty: $0.00Gravity: 01Issued: February 19, 2003Abated: ✓ Yes
29 CFR 1910.134(m)(02)
Fall Protection — General Requirements
Other-than-Serious
Penalty: $0.00Gravity: 01Issued: February 19, 2003Abated: ✓ Yes
29 CFR 1910.303(g)(01)
Electrical — General Requirements
Other-than-Serious
Penalty: $0.00Gravity: 01Issued: February 19, 2003Abated: Pending
29 CFR 1910.37(q)(01)
Maintenance of Exit Routes
Other-than-Serious
Penalty: $0.00Gravity: nanIssued: August 4, 1988Abated: ✓ Yes
29 CFR 1910.106(e)(02)
Other-than-Serious
Penalty: $0.00Gravity: nanIssued: August 4, 1988Abated: ✓ Yes
29 CFR 1910.107(b)(05)
Other-than-Serious
Penalty: $0.00Gravity: nanIssued: August 4, 1988Abated: ✓ Yes
This report is compiled from publicly available U.S. Department of Labor enforcement data under the Freedom of Information Act. SVEP Navigator is an independent research and analysis platform and is not affiliated with, endorsed by, or connected to OSHA, the Department of Labor, or any federal agency. Information is provided for research, educational, and compliance planning purposes only and does not constitute legal advice. Penalty amounts shown are proposed penalties and may have been modified through contest proceedings or settlement.
Local Competitor Benchmark

Comparing penalized facilities in CANTON, SD (Exact Industry)

BID-WELL DIVISION OF CMI CORPORATION (This Facility)
$569
21 cit.
CMI TEREX CORPORATION
$6.6K
1 cit.
TEREX CORPORATION
$3.5K
3 cit.
More SD Enforcement Records
SOUTH DAKOTA WHEAT GROWERS ASSOCIATION
MCLAUGHLIN, SD
$1.8M
43 cit.
JOHN MORRELL & COMPANY
SIOUX FALLS, SD
$1.1M
175 cit.
MINNESOTA RUBBER COMPANY, DIV. OF QUADION CORP.
WATERTOWN, SD
$660.0K
40 cit.
ADAMS THERMAL SYSTEMS, INC.
CANTON, SD
$461.0K
75 cit.
AMTEC CORPORATION
CLEAR LAKE, SD
$246.0K
28 cit.
Other Inspected Facilities in CANTON, SD
ADAMS THERMAL SYSTEMS, INC.
$461.0K
75 cit.
HULSTEIN EXCAVATING INC
$11.2K
3 cit.
CMI TEREX CORPORATION
$6.6K
1 cit.
RUTTEN STRUCTURES, INC.
$5.9K
8 cit.
M & L MASONRY
$5.8K
6 cit.
Related Guides & Tools
OSHA Fines & Penalties Guide →
How OSHA calculates penalties and maximum fine amounts.
Top 10 OSHA Violations →
The most frequently cited standards nationwide.
Manufacturing Safety Data →
Industry-wide violation stats and rankings.
Penalty Calculator →
Estimate fines by violation type, industry, and size.

Explore more: OSHA enforcement in CANTON · South Dakota data · Search the database · Incident Rate Calculator

Frequently Asked Questions
What OSHA violations was BID-WELL DIVISION OF CMI CORPORATION cited for?

BID-WELL DIVISION OF CMI CORPORATION received 21 citation(s) covering 10 distinct OSHA standards. Total proposed penalties were $568.75. The inspection opened on 2003-02-04.

How much was BID-WELL DIVISION OF CMI CORPORATION fined by OSHA?

OSHA proposed penalties of $568.75 against BID-WELL DIVISION OF CMI CORPORATION in CANTON, SD. Average per citation: $27.08.

Is BID-WELL DIVISION OF CMI CORPORATION a safe workplace?

Based on enforcement records, BID-WELL DIVISION OF CMI CORPORATION has a risk score of 20 out of 100. The volume of citations issued during this inspection suggests systematic compliance deficiencies rather than isolated incidents. Facilities with 10 or more citations typically face comprehensive abatement requirements and may be subject to follow-up inspections.

How does this penalty compare to the industry average?

The average penalty for Construction Machinery Manufacturing facilities is $6,436.62. This facility penalty of $568.75 is below the industry average.