TOOLS DIES & MOLDS CO

According to U.S. Department of Labor enforcement records, TOOLS DIES & MOLDS CO — a motor vehicle parts manufacturing facility located at 3003 RYAN RD, NEW HAVEN, IN 46774 — was the subject of a formal OSHA inspection that resulted in 4 citation(s) and cumulative proposed penalties of $1,933.75. The inspection case was opened on 2011-01-24.

DOL records document workplace safety violations warranting formal citation under the OSH Act. While classified at the standard enforcement level, all OSHA citations require corrective action and may indicate areas where workplace safety programs should be strengthened.

BLS Injury Data: According to the Bureau of Labor Statistics (2022), this industry sector has an occupational injury rate of 3.3 per 100 full-time workers — 22% above the national average of 2.7. The sector fatality rate is 2.3 per 100,000 workers.

Industry Benchmark: The total penalty of $1,933.75 is 70% below the national average of $6,436.62 for facilities in the Manufacturing sector (NAICS 336399). This sector encompasses 82,943 inspected facilities nationwide with aggregate penalties totaling $533.9M.

State Context: Within IN, this facility's penalty places it at the 84th percentile among 60,580 inspected facilities. The statewide average penalty is $1,266.78.

Citation Analysis: The inspection produced 4 citations spanning 3 distinct OSHA regulatory standards. The citation breakdown includes: 4 serious — A workplace hazard that could cause death or serious physical harm exists, and the employer knew or should have known about the condition.

Enforcement Timeline: Citations were issued beginning February 15, 2011 with the latest abatement deadline set for April 4, 2011. Of the 4 total citations, 2 (50%) have been marked as abated in DOL records, suggesting partial progress toward required corrective actions.

Penalty Assessment: The total proposed penalty of $1,933.75 falls within OSHA's standard enforcement range and may have been adjusted through informal settlement conference procedures, penalty reduction factors, or good faith credit for demonstrated safety and health management systems.