Tier 5 Standard

AJIN USA

📍 1500 COUNTY ROAD 177, CUSSETA, AL 36852🏭 Motor Vehicle Metal Stamping (NAICS 336370)📅 2012-09-13
$10,150.00
Total Penalties
7
Citations
5/100
Risk Score
409
Analysis Words
Enforcement Analysis

According to U.S. Department of Labor enforcement records, AJIN USA — a motor vehicle metal stamping facility located at 1500 COUNTY ROAD 177, CUSSETA, AL 36852 — was the subject of a formal OSHA inspection that resulted in 7 citation(s) and cumulative proposed penalties of $10,150.00. The inspection case was opened on 2012-09-13.

DOL records document workplace safety violations warranting formal citation under the OSH Act. While classified at the standard enforcement level, all OSHA citations require corrective action and may indicate areas where workplace safety programs should be strengthened.

BLS Injury Data: According to the Bureau of Labor Statistics (2022), this industry sector has an occupational injury rate of 3.3 per 100 full-time workers — 22% above the national average of 2.7. The sector fatality rate is 2.3 per 100,000 workers.

EPA Environmental Record: The EPA shows no current violations for this facility. regulated under: Clean Water Act. Source: EPA ECHO database.

Industry Benchmark: The total penalty of $10,150.00 is 58% above the national average of $6,436.62 for facilities in the Manufacturing sector (NAICS 336370). This sector encompasses 82,943 inspected facilities nationwide with aggregate penalties totaling $533.9M.

State Context: Within AL, this facility's penalty places it at the 93th percentile among 30,935 inspected facilities. The statewide average penalty is $3,893.70.

Citation Analysis: The inspection produced 7 citations spanning 5 distinct OSHA regulatory standards. The citation breakdown includes: 4 serious — A workplace hazard that could cause death or serious physical harm exists, and the employer knew or should have known about the condition. 3 other-than-serious — The violation has a direct relationship to job safety and health but is unlikely to cause death or serious physical harm.

Enforcement Timeline: Citations were issued beginning September 28, 2011 with the latest abatement deadline set for November 3, 2011. Of the 7 total citations, 4 (57%) have been marked as abated in DOL records, suggesting partial progress toward required corrective actions.

Penalty Assessment: The cumulative penalty of $10,150.00 reflects OSHA's gravity-based penalty calculation methodology, which considers the severity of potential injury, the probability of occurrence, the employer's size, good faith, and violation history. The per-citation average of $1,450.00 falls within the standard penalty range.

Industry Benchmark (AL)

This facility's $10,150 penalty is higher than 36% of all penalized companies in the NAICS 336370 industry in AL. The state average penalty for this industry is $118,363.

$118,363
State Avg
$10,150
This Facility
Citation Matrix — 7 Citations
29 CFR 1910.147(c)(04)
Control of Hazardous Energy (Lockout/Tagout)
Serious
Penalty: $3,500.00Gravity: 05Issued: September 28, 2011Abated: ✓ Yes
29 CFR 1910.212(a)(03)
Machine Guarding — General Requirements
Serious
Penalty: $2,975.00Gravity: 05Issued: September 28, 2011Abated: Pending
29 CFR 1910.305(b)(01)
Electrical — Wiring Methods & Components
Serious
Penalty: $2,975.00Gravity: 05Issued: September 28, 2011Abated: Pending
29 CFR 1910.305(b)(01)
Electrical — Wiring Methods & Components
Serious
Penalty: $0.00Gravity: 05Issued: September 28, 2011Abated: Pending
29 CFR 1904.32(b)(01)
Other-than-Serious
Penalty: $700.00Gravity: 00Issued: September 28, 2011Abated: ✓ Yes
29 CFR 1910.134(c)(02)
Fall Protection — General Requirements
Other-than-Serious
Penalty: $0.00Gravity: 01Issued: September 28, 2011Abated: ✓ Yes
29 CFR 1910.147(c)(05)
Control of Hazardous Energy (Lockout/Tagout)
Other-than-Serious
Penalty: $0.00Gravity: 01Issued: September 28, 2011Abated: ✓ Yes
This report is compiled from publicly available U.S. Department of Labor enforcement data under the Freedom of Information Act. SVEP Navigator is an independent research and analysis platform and is not affiliated with, endorsed by, or connected to OSHA, the Department of Labor, or any federal agency. Information is provided for research, educational, and compliance planning purposes only and does not constitute legal advice. Penalty amounts shown are proposed penalties and may have been modified through contest proceedings or settlement.
Local Competitor Benchmark

Comparing penalized facilities in CUSSETA, AL (Broader Sector)

AJIN USA (This Facility)
$10.2K
7 cit.
JOON, LLC
$2.5M
55 cit.
MP-TECH AMERICA, LLC
$28.7K
19 cit.
GREAT LAKES METAL STAMPING, INC.
$27.2K
17 cit.
More AL Enforcement Records
MDLG, INC.
PHENIX CITY, AL
$2.7M
51 cit.
JOON, LLC
CUSSETA, AL
$2.5M
55 cit.
GENE T. JONES TIRE & BATTERY DISTRIBUTORS, INC.
BIRMINGHAM, AL
$1.2M
108 cit.
WHITESELL CORPORATION
TUSCUMBIA, AL
$805.5K
23 cit.
DOLLAR GENERAL CORPORATION/ DOLGENCORP, LLC
TOWN CREEK, AL
$555.2K
7 cit.
Other Inspected Facilities in CUSSETA, AL
JOON, LLC
$2.5M
55 cit.
MP-TECH AMERICA, LLC
$28.7K
19 cit.
GREAT LAKES METAL STAMPING, INC.
$27.2K
17 cit.
JOYNUS STAFFING, CORP.
$17.5K
2 cit.
ALLIANCE HR, INC.
$16.0K
2 cit.
Related Guides & Tools
OSHA Fines & Penalties Guide →
How OSHA calculates penalties and maximum fine amounts.
After an OSHA Inspection →
Citations, appeals, and penalty negotiation steps.
Top 10 OSHA Violations →
The most frequently cited standards nationwide.
Manufacturing Safety Data →
Industry-wide violation stats and rankings.

Explore more: OSHA enforcement in CUSSETA · Alabama data · Search the database · Incident Rate Calculator

Frequently Asked Questions
What OSHA violations was AJIN USA cited for?

AJIN USA received 7 citation(s) covering 5 distinct OSHA standards. Total proposed penalties were $10,150.00. The inspection opened on 2012-09-13.

How much was AJIN USA fined by OSHA?

OSHA proposed penalties of $10,150.00 against AJIN USA in CUSSETA, AL. Average per citation: $1,450.00.

Is AJIN USA a safe workplace?

Based on enforcement records, AJIN USA has a risk score of 5 out of 100. DOL records document workplace safety violations warranting formal citation under the OSH Act. While classified at the standard enforcement level, all OSHA citations require corrective action and may indicate areas where workplace safety programs should be strengthened.

How does this penalty compare to the industry average?

The average penalty for Motor Vehicle Metal Stamping facilities is $6,436.62. This facility penalty of $10,150.00 is above the industry average.