Tier 4 Systematic

FAG BEARINGS CORPORATION

📍 3900 SOUTH RANGELINE ROAD, JOPLIN, MO 64804🏭 Ball and Roller Bearing Manufacturing (NAICS 332991)📅 2006-01-11
$7,040.50
Total Penalties
21
Citations
21/100
Risk Score
386
Analysis Words
Enforcement Analysis

According to U.S. Department of Labor enforcement records, FAG BEARINGS CORPORATION — a ball and roller bearing manufacturing facility located at 3900 SOUTH RANGELINE ROAD, JOPLIN, MO 64804 — was the subject of a formal OSHA inspection that resulted in 21 citation(s) and cumulative proposed penalties of $7,040.50. The inspection case was opened on 2006-01-11.

The volume of citations issued during this inspection suggests systematic compliance deficiencies rather than isolated incidents. Facilities with 10 or more citations typically face comprehensive abatement requirements and may be subject to follow-up inspections.

BLS Injury Data: According to the Bureau of Labor Statistics (2022), this industry sector has an occupational injury rate of 3.3 per 100 full-time workers — 22% above the national average of 2.7. The sector fatality rate is 2.3 per 100,000 workers.

Industry Benchmark: The total penalty of $7,040.50 is approximately in line with the national average of $6,436.62 for facilities in the Manufacturing sector (NAICS 332991). This sector encompasses 82,943 inspected facilities nationwide with aggregate penalties totaling $533.9M.

State Context: Within MO, this facility's penalty places it at the 90th percentile among 41,963 inspected facilities. The statewide average penalty is $2,902.40.

Citation Analysis: The inspection produced 21 citations spanning 11 distinct OSHA regulatory standards. The citation breakdown includes: 3 other-than-serious — The violation has a direct relationship to job safety and health but is unlikely to cause death or serious physical harm. 12 serious — A workplace hazard that could cause death or serious physical harm exists, and the employer knew or should have known about the condition.

Enforcement Timeline: Citations were issued beginning March 17, 2006 with the latest abatement deadline set for October 17, 2006. Of the 21 total citations, 13 (62%) have been marked as abated in DOL records, suggesting partial progress toward required corrective actions.

Penalty Assessment: The total proposed penalty of $7,040.50 falls within OSHA's standard enforcement range and may have been adjusted through informal settlement conference procedures, penalty reduction factors, or good faith credit for demonstrated safety and health management systems.

Citation Matrix — 21 Citations
29 CFR 1910.1200(f)(09)
Hazard Communication Standard (Chemical Safety)
Other-than-Serious
Penalty: $0.00Gravity: 01Issued: March 17, 2006Abated: ✓ Yes
29 CFR 1910.23(a)(02)
Guarding Floor & Wall Openings
Serious
Penalty: $750.00Gravity: 02Issued: March 17, 2006Abated: ✓ Yes
29 CFR 1910.219(c)(03)
Mechanical Power Transmission
Serious
Penalty: $562.50Gravity: 01Issued: March 17, 2006Abated: ✓ Yes
29 CFR 1910.219(d)(01)
Mechanical Power Transmission
Serious
Penalty: $562.50Gravity: 01Issued: March 17, 2006Abated: ✓ Yes
29 CFR 1910.219(f)(03)
Mechanical Power Transmission
Serious
Penalty: $562.50Gravity: 01Issued: March 17, 2006Abated: ✓ Yes
29 CFR 1910.242(b)
Serious
Penalty: $478.00Gravity: 01Issued: March 17, 2006Abated: Pending
29 CFR 1910.253(e)(03)
Serious
Penalty: $562.50Gravity: 01Issued: March 17, 2006Abated: ✓ Yes
29 CFR 1910.303(f)
Electrical — General Requirements
Serious
Penalty: $562.50Gravity: 01Issued: March 17, 2006Abated: ✓ Yes
29 CFR 1910.304(f)(04)
Electrical — Wiring Design & Protection
Serious
Penalty: $562.50Gravity: 01Issued: March 17, 2006Abated: ✓ Yes
29 CFR 1910.305(b)(01)
Electrical — Wiring Methods & Components
Serious
Penalty: $562.50Gravity: 01Issued: March 17, 2006Abated: ✓ Yes
29 CFR 1910.134(c)(01)
Fall Protection — General Requirements
Other-than-Serious
Penalty: $0.00Gravity: 01Issued: March 17, 2006Abated: ✓ Yes
29 CFR 1910.1030(c)(01)
Other-than-Serious
Penalty: $0.00Gravity: 01Issued: March 17, 2006Abated: Pending
29 CFR 1910.305(g)(01)
Electrical — Wiring Methods & Components
Serious
Penalty: $562.50Gravity: 01Issued: March 17, 2006Abated: ✓ Yes
29 CFR 1910.95(d)(03)
Serious
Penalty: $562.50Gravity: 01Issued: March 17, 2006Abated: ✓ Yes
29 CFR 1910.95(j)(04)
Serious
Penalty: $0.00Gravity: 01Issued: March 17, 2006Abated: ✓ Yes
This report is compiled from publicly available U.S. Department of Labor enforcement data under the Freedom of Information Act. SVEP Navigator is an independent research and analysis platform and is not affiliated with, endorsed by, or connected to OSHA, the Department of Labor, or any federal agency. Information is provided for research, educational, and compliance planning purposes only and does not constitute legal advice. Penalty amounts shown are proposed penalties and may have been modified through contest proceedings or settlement.
Local Competitor Benchmark

Comparing penalized facilities in JOPLIN, MO (Exact Industry)

FAG BEARINGS CORPORATION (This Facility)
$7.0K
21 cit.
FAG BEARING CORPORATION
$19.2K
30 cit.
FAG BEARINGS
$15.2K
24 cit.
More MO Enforcement Records
THOMAS INDUSTRIAL COATINGS, INC.
KANSAS CITY, MO
$1.5M
43 cit.
ZMDR LLC
LONE JACK, MO
$654.5K
48 cit.
DNRB, INC.
KANSAS CITY, MO
$511.0K
11 cit.
BUTTERBALL TURKEY COMPANY
CARTHAGE, MO
$508.2K
123 cit.
DOE RUN COMPANY
HERCULANEUM, MO
$440.4K
145 cit.
Other Inspected Facilities in JOPLIN, MO
DOANE PET CARE COMPANY
$103.0K
11 cit.
JASPER PRODUCTS
$53.6K
11 cit.
PROTEIN FOR PETS OPCO, LLC
$45.8K
6 cit.
HS BAKING
$43.0K
4 cit.
GATOR INDUSTRIAL, LLC
$43.0K
7 cit.
Related Guides & Tools
OSHA Fines & Penalties Guide →
How OSHA calculates penalties and maximum fine amounts.
After an OSHA Inspection →
Citations, appeals, and penalty negotiation steps.
Top 10 OSHA Violations →
The most frequently cited standards nationwide.
Manufacturing Safety Data →
Industry-wide violation stats and rankings.

Explore more: OSHA enforcement in JOPLIN · Missouri data · Search the database · Incident Rate Calculator

Frequently Asked Questions
What OSHA violations was FAG BEARINGS CORPORATION cited for?

FAG BEARINGS CORPORATION received 21 citation(s) covering 11 distinct OSHA standards. Total proposed penalties were $7,040.50. The inspection opened on 2006-01-11.

How much was FAG BEARINGS CORPORATION fined by OSHA?

OSHA proposed penalties of $7,040.50 against FAG BEARINGS CORPORATION in JOPLIN, MO. Average per citation: $335.26.

Is FAG BEARINGS CORPORATION a safe workplace?

Based on enforcement records, FAG BEARINGS CORPORATION has a risk score of 21 out of 100. The volume of citations issued during this inspection suggests systematic compliance deficiencies rather than isolated incidents. Facilities with 10 or more citations typically face comprehensive abatement requirements and may be subject to follow-up inspections.

How does this penalty compare to the industry average?

The average penalty for Ball and Roller Bearing Manufacturing facilities is $6,436.62. This facility penalty of $7,040.50 is above the industry average.