Tier 5 Standard

AERSALE COMPONENT SOLUTIONS

📍 4901 ROCKAWAY BLVD NE, RIO RANCHO, NM 87124🏭 Other Aircraft Parts and Auxiliary Equipment Manufacturing (NAICS 336413)📅 2019-08-20
$7,500.00
Total Penalties
5
Citations
3/100
Risk Score
396
Analysis Words
Enforcement Analysis

According to U.S. Department of Labor enforcement records, AERSALE COMPONENT SOLUTIONS — a other aircraft parts and auxiliary equipment manufacturing facility located at 4901 ROCKAWAY BLVD NE, RIO RANCHO, NM 87124 — was the subject of a formal OSHA inspection that resulted in 5 citation(s) and cumulative proposed penalties of $7,500.00. The inspection case was opened on 2019-08-20.

DOL records document workplace safety violations warranting formal citation under the OSH Act. While classified at the standard enforcement level, all OSHA citations require corrective action and may indicate areas where workplace safety programs should be strengthened.

BLS Injury Data: According to the Bureau of Labor Statistics (2022), this industry sector has an occupational injury rate of 3.3 per 100 full-time workers — 22% above the national average of 2.7. The sector fatality rate is 2.3 per 100,000 workers.

EPA Environmental Record: The EPA currently lists this facility under Violation status. EPA penalties total $2,500.00 (Hazardous Waste (RCRA): $2,500.00). Source: EPA ECHO database.

Industry Benchmark: The total penalty of $7,500.00 is approximately in line with the national average of $6,436.62 for facilities in the Manufacturing sector (NAICS 336413). This sector encompasses 82,943 inspected facilities nationwide with aggregate penalties totaling $533.9M.

State Context: Within NM, this facility's penalty places it at the 95th percentile among 8,892 inspected facilities. The statewide average penalty is $1,937.30.

Citation Analysis: The inspection produced 5 citations spanning 1 distinct OSHA regulatory standards. The citation breakdown includes: 5 serious — A workplace hazard that could cause death or serious physical harm exists, and the employer knew or should have known about the condition.

Enforcement Timeline: Citations were issued beginning December 30, 2019 with the latest abatement deadline set for January 27, 2020. Of the 5 total citations, 0 (0%) have been marked as abated in DOL records, which may indicate ongoing compliance gaps requiring further regulatory attention.

Penalty Assessment: The total proposed penalty of $7,500.00 falls within OSHA's standard enforcement range and may have been adjusted through informal settlement conference procedures, penalty reduction factors, or good faith credit for demonstrated safety and health management systems.

Citation Matrix — 5 Citations
29 CFR 1910.134(c)(01)
Fall Protection — General Requirements
Serious
Penalty: $7,500.00Gravity: 5Issued: December 30, 2019Abated: Pending
29 CFR 1910.134(c)(01)
Fall Protection — General Requirements
Serious
Penalty: $0.00Gravity: 5Issued: December 30, 2019Abated: Pending
29 CFR 1910.134(c)(01)
Fall Protection — General Requirements
Serious
Penalty: $0.00Gravity: 5Issued: December 30, 2019Abated: Pending
29 CFR 1910.134(c)(01)
Fall Protection — General Requirements
Serious
Penalty: $0.00Gravity: 5Issued: December 30, 2019Abated: Pending
29 CFR 1910.134(k)
Fall Protection — General Requirements
Serious
Penalty: $0.00Gravity: 5Issued: December 30, 2019Abated: Pending
This report is compiled from publicly available U.S. Department of Labor enforcement data under the Freedom of Information Act. SVEP Navigator is an independent research and analysis platform and is not affiliated with, endorsed by, or connected to OSHA, the Department of Labor, or any federal agency. Information is provided for research, educational, and compliance planning purposes only and does not constitute legal advice. Penalty amounts shown are proposed penalties and may have been modified through contest proceedings or settlement.
Local Competitor Benchmark

Comparing penalized facilities in RIO RANCHO, NM (Exact Industry)

AERSALE COMPONENT SOLUTIONS (This Facility)
$7.5K
5 cit.
AERO PARTS MANUFACTURING & REPAIR
$6.7K
20 cit.
AERO PARTS MANUFACTURING & REPAIR INC
$6.5K
5 cit.
More NM Enforcement Records
CONSOLIDATED BUILDERS OF NM, LLC
ALBUQUERQUE, NM
$331.5K
13 cit.
ALIYAS FOODS USA INC
ALBUQUERQUE, NM
$219.0K
3 cit.
O'REILLY AUTOMOTIVE STORES, INC.
SANTA FE, NM
$217.1K
5 cit.
ROSWELL, CITY OF, WATER DEPARTMENT
ROSWELL, NM
$155.4K
5 cit.
SOUTHWEST STUCCO
LAS CRUCES, NM
$133.8K
7 cit.
Other Inspected Facilities in RIO RANCHO, NM
AERSALE COMPONENTS SOLUTIONS
$67.5K
11 cit.
THE NEIGHBORHOOD IN RIO RANCHO LIFE PLAN COMMUNITY
$37.3K
6 cit.
FILE LLP
$34.9K
4 cit.
OTERO BROTHERS ROOFING
$33.7K
3 cit.
STONE COLD MASONRY
$31.5K
2 cit.
Related Guides & Tools
OSHA Fines & Penalties Guide →
How OSHA calculates penalties and maximum fine amounts.
After an OSHA Inspection →
Citations, appeals, and penalty negotiation steps.
Top 10 OSHA Violations →
The most frequently cited standards nationwide.
Manufacturing Safety Data →
Industry-wide violation stats and rankings.

Explore more: OSHA enforcement in RIO RANCHO · New Mexico data · Search the database · Incident Rate Calculator

Frequently Asked Questions
What OSHA violations was AERSALE COMPONENT SOLUTIONS cited for?

AERSALE COMPONENT SOLUTIONS received 5 citation(s) covering 1 distinct OSHA standards. Total proposed penalties were $7,500.00. The inspection opened on 2019-08-20.

How much was AERSALE COMPONENT SOLUTIONS fined by OSHA?

OSHA proposed penalties of $7,500.00 against AERSALE COMPONENT SOLUTIONS in RIO RANCHO, NM. Average per citation: $1,500.00.

Is AERSALE COMPONENT SOLUTIONS a safe workplace?

Based on enforcement records, AERSALE COMPONENT SOLUTIONS has a risk score of 3 out of 100. DOL records document workplace safety violations warranting formal citation under the OSH Act. While classified at the standard enforcement level, all OSHA citations require corrective action and may indicate areas where workplace safety programs should be strengthened.

How does this penalty compare to the industry average?

The average penalty for Other Aircraft Parts and Auxiliary Equipment Manufacturing facilities is $6,436.62. This facility penalty of $7,500.00 is above the industry average.