ADM MILLING CO.

According to U.S. Department of Labor enforcement records, ADM MILLING CO. — a flour milling facility located at 540 SOUTH ST, LINCOLN, NE 68502 — was the subject of a formal OSHA inspection that resulted in 45 citation(s) and cumulative proposed penalties of $165,200.00. The inspection case was opened on 2003-12-16.

Cumulative penalties significantly exceed the national median for OSHA enforcement actions. The penalty amount suggests multiple high-gravity citations, indicating conditions that presented a substantial probability of death or serious physical harm to employees.

BLS Injury Data: According to the Bureau of Labor Statistics (2022), this industry sector has an occupational injury rate of 3.3 per 100 full-time workers — 22% above the national average of 2.7. The sector fatality rate is 2.3 per 100,000 workers.

EPA Environmental Record: The EPA shows no current violations for this facility. regulated under: Clean Air Act, RCRA Hazardous Waste. Source: EPA ECHO database.

Industry Benchmark: The total penalty of $165,200.00 is more than 19.4× the national average of $8,527.19 for facilities in the Manufacturing sector (NAICS 311211). This sector encompasses 24,420 inspected facilities nationwide with aggregate penalties totaling $208.2M.

State Context: Within NE, this facility's penalty places it at the 100th percentile among 12,745 inspected facilities. The statewide average penalty is $4,129.57.

Citation Analysis: The inspection produced 45 citations spanning 8 distinct OSHA regulatory standards. The citation breakdown includes: 14 serious — A workplace hazard that could cause death or serious physical harm exists, and the employer knew or should have known about the condition. 1 other-than-serious — The violation has a direct relationship to job safety and health but is unlikely to cause death or serious physical harm.

Enforcement Timeline: Citations were issued beginning July 8, 1997 with the latest abatement deadline set for September 30, 2005. Of the 45 total citations, 15 (33%) have been marked as abated in DOL records, which may indicate ongoing compliance gaps requiring further regulatory attention.

Penalty Assessment: The cumulative penalty of $165,200.00 reflects OSHA's gravity-based penalty calculation methodology, which considers the severity of potential injury, the probability of occurrence, the employer's size, good faith, and violation history. The per-citation average of $3,671.11 falls within the standard penalty range.

The 2003 enforcement action against ADM Milling Co. reveals a pervasive failure